Peptide Tracker

Guides

Injection site rotation: a log and chart that keep it simple

Rotating injection sites is easy to agree with and hard to keep track of. This guide shows how to name your sites, set up a rotation chart, and record each injection so the next site is always obvious.

Most instruction leaflets for subcutaneous injections say the same thing: don’t use the exact same spot every time. One reason often given is that repeated injections in one place can leave the skin sore, hardened or lumpy. Which body areas suit you, and how far apart injections should be, is for your clinician or the product instructions to say. What a log can do is make the rotation you were given easy to follow and easy to check.

Start with a fixed list of site names

A rotation only works if you can tell sites apart in your records. Decide on your names once and use exactly those every time. A typical list for subcutaneous injections uses body area, side and sometimes a zone:

AreaSite namesNotes for the log
AbdomenAbdomen upper left, upper right, lower left, lower rightLeaflets usually say to keep clear of the area right around the navel.
ThighsThigh left, thigh right (front or outer)Add “upper” and “lower” if you split each thigh into zones.
Upper armsArm left, arm right (back of the arm)Often harder to reach yourself, so some people leave these out.
OtherOnly what your instructions listKeep the same spelling every time, such as “Glute left”.

Three rules keep the list useful. Always record the side; left and right are the easiest way to alternate and the detail people most often forget. Don’t mix synonyms: “belly”, “stomach” and “abdomen” in one log look like three different places. And if a site is off limits for a while, such as a spot that is still tender, note that rather than quietly skipping it, so the gap in your rotation makes sense later.

Set up a rotation chart

A rotation chart is just your site list in a fixed order. You work through it top to bottom and start again. Because the order never changes, the last line of your log tells you where the next injection goes.

OrderSiteExample: daily scheduleExample: weekly schedule
1Abdomen upper leftMonWeek 1
2Abdomen upper rightTueWeek 2
3Abdomen lower leftWedWeek 3
4Abdomen lower rightThuWeek 4
5Thigh leftFriWeek 5
6Thigh rightSatWeek 6
Back to 1Abdomen upper leftSunWeek 7

With a daily schedule and six sites, each site comes round every six days. With a weekly schedule, each site gets a long rest between uses, so a shorter list is often enough. If you take more than one injection on the same day, give each its own site and record both, so the rotation doesn’t double back on itself.

Some people prefer to rotate within an area for a while, using different spots in the abdomen before moving on, while others alternate areas every time. Either works for record-keeping, as long as you pick one pattern and the chart reflects it.

What to write for each injection

A rotation log is a normal injection log where the site column does the heavy lifting. For each injection, record:

  • Date and actual time, not the planned time.
  • What and how much, in the same unit every time.
  • Site, using a name from your fixed list, including the side.
  • A short note if anything was different: a site skipped, a reaction, a new vial.
DateTimeAmountSiteNotes
Nov 38:05 AM10 unitsAbdomen upper left
Nov 48:10 AM10 unitsAbdomen upper right
Nov 58:00 AM10 unitsThigh leftSkipped abdomen lower left: still tender

The note on the last line matters. Without it, a reader would think the rotation was broken by mistake. With it, the log explains itself, and a clinician can see at a glance which site was sore and when.

Recording reactions

If you notice anything at a site, write the date, the site name and a few plain words such as “red patch, about the size of a coin” or “small lump, not painful”. Describe what you see rather than what you think it means, and don’t edit earlier entries afterwards. A dated, factual note next to the site name makes patterns visible: if every note points at the same area, that’s worth raising.

Anything that worries you about an injection site is a question for a clinician or pharmacist, not something to manage from a log. The log’s job is to make that conversation quicker and more accurate.

Checking your rotation

Once a week, read down the site column. You’re looking for three things:

  1. Repeats: the same site twice in a row, or more often than the chart says.
  2. Favourites: one area that turns up far more than the others because it’s convenient.
  3. Gaps: sites on your list that never get used. Either use them or take them off the list, so the chart matches what you actually do.

On paper this takes a minute. In a spreadsheet you can count each site name with a filter or a pivot table, which is another reason fixed names matter. Our peptide log template has a site column ready to go.

Let an app keep the chart for you

Peptide Tracker’s injection site tracker records the site with each logged dose from a fixed list with sides, suggests the next site from your recent history and warns you before you reuse a spot you used recently. Your full history, sites included, can be exported to CSV at any time.

Checklist

  • A fixed list of site names, always with the side.
  • A rotation chart in a set order, so the next site is obvious.
  • One line per injection with date, time, amount and site.
  • A short note when you skip a site or notice a reaction.
  • A weekly look down the site column for repeats and favourites.

Keep your log in one place

Peptide Tracker handles schedules, dose logs, vials and reminders for you. It’s free and takes about a minute to set up.

More guides